Clustered Butterfly Gift Wrap

Welcome back! I have some more creative gift wrapping for you today. Next up at the wrapping station:

Clustered Butterfly Gift
 
Materials:
Wrapping Paper
Wire Ribbon
Butterfly hole puncher
Colored scrapbook paper or other colored paper
Snowflake embellishment
Elmer’s glue
Start by using the butterfly hole puncher and punch out oodles of little butterflies.

Crease and fold the butterflies in half to give them some dimension. It is okay to leave a few butterflies flat.

Gift wrap your present as you normally would. And add your ribbon and bow on diagonal corners.


Use Elmer’s glue to place random dots onto your package.

Lay your butterflies on top of the glue. Keep adding butterflies until your cluster is done.

Add a snowflake embellishment and one butterfly on the bow.
“These are a few of my favorite things (butterflies in December!)”
I realize the butterflies are a little feminine, so I have a more unisex gift wrap up next:
3-D Christmas Tree
 
Materials:

Wrapping paper
Curly ribbon
1 – 12″ x 12″ scrapbook paper
Shiny embellishment dots or stickers
Elmer’s glue
Optional: Green construction paper or scrapbook paper for fringe grass at the bottom

Wrap your package as you would normally.

Cut a small square out of craft paper for the trunk. Fold your scrapbook paper into quarters…

…and cut along the fold(s) using the template below.

When you are done you should have two identical trees.

Glue the tree trunk down using Elmer’s glue. Run a bead along the spine of the tree and glue the first tree down on top of the trunk. Run a second bead of glue along the spine of the first tree and lay the second tree on top but slightly lower than the first.

Fold the left and right sides of the tree up to give them some dimension.
 

Add some embellishments or stickers to decorate your tree.

Optional: Adding Fringe Grass

Cut out a strip of green construction paper for your grass line. Tape two pieces together if you need to make it longer.

Cut fringes into the top edge of the green strip.

Using a pencil, roll the fringes over the pencil. I found this worked best on my thigh (probably because of that 10 lbs. of blogger bloat!)

Glue your strip of fringed grass onto the package using Elmer’s glue.

Use your finger to push some fringes up and others down until you like the look.

Finish off your package by tying some curly ribbon onto it.
“Oh Christmas Tree, Oh Christmas Tree”
As I was falling asleep last night, I came up with a few more ideas for creative gift wrapping.  I hope to implement them tonight and then share them with you these final days before Christmas. In other words, I have SIX days of creative gift wrappings lined up for you. So be sure to check out Day #3.
Snowman Gift Wrap

The last few years I found myself up late on December 24th frantically wrapping presents, not exactly the way to get into the spirit! This year I knew I wanted to do it differently. These are the three things I wanted to happen:

  1. I wanted to spend some time being creative while wrapping the presents.
  2. Find some time to spend with friends that didn’t involve eating cookies (I have to admit, I’ve gained 10 lbs. since I began blogging, I’ll refer to it at the new blogger’s bloat.)
  3. And finally, give myself time to really get creative and then share the results with my readers.

My genius plan was to have a girlfriend get together and wrapping party. So, I invited four girlfriends to come chat and wrap.

Unfortunately a stomach bug, an out-of-town hubby, and life with kids put a damper on everyone’s plans except Renee’s. Despite our small numbers, we still had fun talking, catching up and wrapping some creative packages!

Over the next few days I’ll share with you the tutorials. I hope you get some ideas for your gifts (if you still haven’t wrapped yours). And I hope you don’t spend the evening of December 24th wrapping them all by yourself.

Snowman Present

Materials:

Black felt or black construction paper
Cake size paper plate
Buttons (2 eyes, 1 nose, 5-6 mouth)
Red Ribbon
Snowflake stickers, snowflake paper punch, and/or other embellishments
Wrapping paper
Elmer’s glue
Hot Glue Gun

Start by wrapping your present as you would normally.
Preheat your hot glue gun.
Then cut out your black felt or construction paper in the shape of a hat. Feel free to use this template or make your own.

Cut a piece of red ribbon for the brim of your snowman’s hat. Then gather your snowman pieces and lay them out on your package.
Use the hot glue gun to glue the cake plate upside down to the package.
Then glue the brim ribbon to the hat.
Glue your hat on the package letting the brim overlap the cake plate.
Cut another piece of ribbon for your snowman’s scarf and fold it in half. From the folded edge, you will want to fold about 2 inches back on itself. This will be your snowman’s scarf knot. Play with the scarf and “knot” until you like how it looks, then use the hot glue to affix it to the gift box.
Use some more hot glue to adhere the buttons to the cake plate.
Then embellish your package with snowflake stickers, etc. Besides the stickers, I used the snowflake hole punch to punch many little flakes. Then I glued them with a small dot of elmer’s glue.
 “Frosty the Snowman!”
Rudolf Gift Wrap
Materials:
Two twigs
Brown craft paper or paper bag
Two buttons for eyes
1 Red pom pom
Red Ribbon
Snowflake stickers or hole punches
Jingle bell
Elmer’s glue
Hot glue gun
Preheat your hot glue gun.
Wrap your present as you normally would.
Cut out a reindeer head from the craft paper or a paper bag. Feel free to use this template or make your own.
Lay out your reindeer pieces on the package where you want them.
Coat the back of the reindeer head with Elmer’s glue and attach it to your gift.
Using your hot glue gun, run a thick line of glue onto the back of your twigs and attach them over the reindeer head.
Use hot glue to attach the eyes and nose.
Tie a bow with your red ribbon. Attach a gift tag and jingle bell to the bow and then hot glue it to the package.
Finish off decorating your gift by adding paper punch snowflakes with elmer’s glue and/or stickers.
“Rudolf the Red Nose Reindeer!”
 
Side note: I bought the paper punch, stickers, and embellishments in the scrap-booking aisle at Target. And our Costco has the biggest spools of wired ribbon I’ve ever seen.
Be sure to check back these last few days before Christmas because I have SIX days of creative gift wrappings to share with you! Head on over to Day #2.

VotivesonShelf.jpg
Glass Jar Votive Holders

This has to be one of my favorite activities to do with the kids!

Start by saving jars for a month or more! Salsa, jelly, vegetable, and baby jars all work well. Soak the jars to remove the labels and scrub any excess glue off.

Materials:
Materials.jpg
  • Clean Jars
  • Mod Podge (or diluted School Glue)
  • Brushes
  • Jar of water to rest brushes in
  • Tissue Paper (I limited the palette to whites and blues)
  • Magazine cut outs, sheet music, stickers, or decorative hole punches
  • Plastic tablecloth or sheet to cover your work area

1. Tear your tissue paper, sheet music, or other paper into small strips and/or cut magazine pictures into small pieces.

TornPaper.jpg

2. Brush a coating of Mod Podge onto the outside of the jar.

1stCoatModPodge.jpg

3. Lay down your first layer of papers. (You be the creative genius here! You really can’t go wrong.)

AddTissueSnowFlake.jpg

4. Coat the top of your paper layer with more Mod Podge and continue until the jar has been covered. It is okay to and encouraged to overlap layers. (Again, you are the creative genius!)

2ndCoatModPodge.jpg

5. Finish your jar by brushing on a final coating of Mod Podge. Be sure everything has been coated.

DryingJars.jpg

6. Rest your votive holders on wax paper to dry. (Did you know that I never buy wax paper anymore? I use recycled cereal bags.) After an hour, flip your jars over to allow the other end to dry.

VotivesonCounter.jpg
Insert your tea lights or use flame-less candles and enjoy!

 

They are so adorable, that after the season has passed, I’ve been known to use these for pencil holders, for makeup brushes or impromptu vases for a bud or two. They also make a great gift from your child to an adoring Grandparent!  What do you think? Are they gift-worthy?

Sew Mini Gift Pouches from Napkins

AllPouches.jpgOh the quandary of what to get my boy’s teachers, the sitter, and all those other important people in our lives. Usually I take the easy way out and buy gift cards. Well – okay – I’m still going to give the gift cards, but this year I wanted to present them in something a little nicer. Something handmade with love. Cute mini gift pouches!

These little handmade pouches are perfect for holding a gift card and some holiday treats. And then after the holiday season has ended, the recipient can use the pouch to protect and store valuables!

My pouches started like this:

DiscountNapkins.jpg

Discounted cloth napkins! 90 cents for each napkin. And here is how they became cute little mini gift pouches:

CutinQuarters.jpg

Open the napkin up and cut it into quarters.

FoldinHalf.jpg

Fold the napkin in half.

LayoutButtons.jpg

Allow 1/4 inch seam allowance on the open edge of your pouch, then layout your design and sketch with a disappearing marker where your stitch lines will appear.

SewStems.jpg

Sew along the lines you drew. (My machine has a few decorative stitches, but I could have done them by hand instead.)

SewOnButton.jpg

Then hand sew the buttons on where you want them.

HemPouch.jpg

Once your design has been completely stitched You will need to hem the raw edge on your napkin.

FoldOverDrawstring.jpg

Next, fold over the top of your pouch approximately 1/2″ to accommodate your ribbon drawstring.

DecorativeTopStitch.jpg

Stitch the ribbon drawstring pocket closed. If your sewing machine has decorative stitches you may choose to use one of them, but be sure to sew on the right side.

StitchLines.jpg

Fold your napkin back in half with the right sides together, and stitch along the bottom and open sides of your pouch. (I stitched this pouch a little higher on the bottom edge to make the flower stems end in the seam.) Be careful to stop stitching up the side before the drawstring opening.

CutCorners.jpg

Snip off the corners of your pouch.

TurnRightSideOut.jpg

Turn your pouch right side out.

FeedSafetyPin.jpg

Cut a length of ribbon long enough to thread through the top of your pouch and to tie a bow. Then attach a safety pin to one end of the ribbon. (I added some scotch tape so the pin wouldn’t fray the ribbon.)

PulledSafetyPin.jpg

Gently feed the ribbon through the bag using the safety pin to push its way through.

FlowerPouch.jpg

Add some goodies to your pouches and tie the ribbon to close it up.

AllPouches.jpg

For the Rudolf and tree bag, I simply cut out the shapes using felt and stitched around the edges.

SnowmanEyeballs.jpg

One more trick for you. The snowman’s eyes were added after I stitched the button on using white thread. Then I re-threaded my needle and sewed in and out a few times on each hole to give him little black eyes.

I will be the first to admit that I need to center my designs a little better, but for now I’m happy with them. And, hey, isn’t it the imperfections that make them look handmade?

https://3.bp.blogspot.com/_g5zUd7bijOw/TP5MiaPwgSI/AAAAAAAADLs/GU1XOSrD1_I/s1600/MoreXmasPouches.jpg

Update: I made a few more pouches last night, and altered my snowmen to a four hole button which gave me the option to add a mouth. I’m also perfecting my technique and getting better (not perfect) at centering the designs.

 

 

Pin for later!

DIY Christmas gift pouches made from napkins

CloseUpWreath.jpg
Sneak Peek at my Christmas Wreath

I am getting a lot of mileage out of my white base wreath I bought at Target several months ago. With it I’ve been able to make a Magnolia Leaf Wreath for the fall.

welcomewreath.jpg

I made a Feather Wreath for Thanksgiving.

SideViewWreath.jpg

Now it was time to give the wreath an injection of Christmas spirit. I removed the feathers, but left the green nuts on it. I had a green fabric leaf wreath that I made out of some floral filler stalks. All I did was twist 4 of the stalks into a circle shape and secure with a few pieces of floral wire.

2Wreaths.jpg

I set my white base wreath inside the green leaf circle.

TogetherasOne.jpg

To secure the two together, 1) I fed some of the base wreath twigs under the leaf wreath and 2) twisted them over to hug the green leaf wreath.

FoldUpSpring.jpg

That couldn’t be any easier! No glue, no mess.

I compared two different ribbons next to my wreath and ultimately chose the black and white one.

2Ribbons.jpg

Tied a pretty bow and stood back to admire.

BandWWreath.jpg

Hmmm, I like it, but it just wasn’t feeling Christmasy enough, so I quickly tucked some red floral sprigs with teeny bells on them into the wreath and gently curved them to match the shape of the wreath.

FinalWreath.jpg
Now that is more like it!
In less than 10 minutes I have my Christmas wreath! This base wreath has been the best $10 I’ve spent all year!

I’m going to try to use this wreath all year and will be sure to share the transformations with you.